bluechictl is a convenience CLI tool to interact with bluechi Usage: bluechictl [command] Available commands: - help: shows this help message usage: help - list-unit-files: returns the list of systemd service files installed on a specific or on all nodes usage: list-unit-files [nodename] [--filter=glob] - list-units: returns the list of systemd services running on a specific or on all nodes usage: list-units [nodename] [--filter=glob] - start: starts a specific systemd service (or timer, or slice) on a specific node usage: start nodename unitname - stop: stop a specific systemd service (or timer, or slice) on a specific node usage: stop nodename unitname - freeze: freeze a specific systemd service on a specific node usage: freeze nodename unitname - thaw: thaw a frozen systemd service on a specific node usage: thaw nodename unitname - reload: reloads a specific systemd service (or timer, or slice) on a specific node usage: reload nodename unitname - restart: restarts a specific systemd service (or timer, or slice) on a specific node usage: restart nodename unitname - reset-failed: reset failed node on all node or all units on a specific node or specidec units on a node usage: reset-failed [nodename] [unit1, unit2 ...] - kill: kills processes of a specific unit on the given node usage: kill [nodename] [unit] [--kill-whom=all|main|control] [--signal=] - enable: enables the specified systemd files on a specific node usage: enable nodename unitfilename... - disable: disables the specified systemd files on a specific node usage: disable nodename unitfilename... - metrics [enable|disable]: enables/disables metrics reporting usage: metrics [enable|disable] - metrics listen: listen and print incoming metrics reports usage: metrics listen - monitor: creates a monitor on the given node to observe changes in the specified units usage: monitor [node] [unit1,unit2,...] - status: shows the status of a node, or statuses of all nodes, or status of a unit on node usage: status [nodename [unitname]] [-w/--watch] - daemon-reload: reload systemd daemon on a specific node usage: daemon-reload nodename - set-loglevel: change the log level of the bluechi-controller or a connected node usage: set-loglevel [nodename] [loglevel] - get-default: get a default target of connected node usage: get-default [nodename] - set-default: set a default target of connected node usage: set-default [nodename] [target]